Skoda Superb 2014 Owner's Manual page 83

Raising or lowering the curvature of the lumbar support
›
Push the switch in the region of one of the arrows1
A
The adjusted driver's seat position can be set in the memory of the
seat » page 82 or the remote control key
Note
If the setting procedure is interrupted, you will need to press the button again.
Head restraints
Fig. 68 Head restraints: setting / removing

Read and observe on page 79 first.
Best protection is achieved if the top edge of the head rest is at the same level
as the upper part of your head.
Setting height
›
Grasp the side of the head restraint with both hands and push it upwards as
required » Fig. 68 - .
» Fig. 66.
» page 82.
Fig. 69
Rear centre head rests in vehi-
cles with the TOP TETHER sys-
tem
›
To move the head restraint downwards, press and hold the safety but-
ton » Fig. 68 -  with one hand and push the head restraint down with the
other hand.
The front seats and head rests must be adjusted to match the body size at all
times and the seat belt must always be fastened properly to provide the most
effective levels of protection to the passengers
seated position.
Removing/installing
›
Pull the head restraint up out of the seat backrest as far as the stop (for the
rear head restraints fold the seat backrest forward).
›
Press the locking button in the direction of the arrow
the head restraint out.
›
To re-insert the head restraint, push it far enough down into the seat back-
rest until the locking button clicks into place.
Removing and installing rear middle head rest
Applies to vehicles using the TOP TETHER system.
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
press the locking button into the opening
width of maximum 5 mm and pull out the head rest.
›
To re-insert the head restraint, push it far enough down into the seat back-
rest until the locking button clicks into place.
WARNING
The head rests must be correctly adjusted to avoid risk of injury.
■
Never drive with the head restraints removed - risk of injury.
■
If the rear seats are occupied, the rear head rests must not be in the low-
■
er position.
Note
The middle rear head restraint is adjustable in two positions.
» page 7, Correct and safe
» Fig. 68 -  and pull
» Fig. 69 simultaneously
1
using a flat screwdriver with a
2
Seats and useful equipment
81