Skoda Superb 2014 Owner's Manual page 207

WARNING
A tyre filled with sealant has the same driving characteristics as a stand-
■
ard tyre.
Do not travel faster than 80 km/h.
■
Avoid accelerating at full throttle, sharp braking and fast cornering.
■
Check the tyre pressure after driving for 10 minutes.
■
The sealant is hazardous to heath. Remove immediately if it comes into
■
contact with the skin.
For the sake of the environment
Used sealant or sealant whose expiry date has passed must be disposed of in
accordance with environmental protection regulations.
Note
Observe the manufacturer's usage instructions for the breakdown kit.
■
A new bottle of sealant can be purchased from ŠKODA Original Parts.
■
Immediately replace the tyre that was repaired using the breakdown kit, or
■
consult a specialist garage about repair options.
Breakdown kit
Fig. 181 Principle sketch: Components of the breakdown kit

Read and observe on page 205 first.
The kit is located in a box under the floor covering in the luggage compart-
ment.
Components of the breakdown kit
Valve remover
1
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
2
Inflation hose with plug
3
Air compressor
4
Tyre inflation hose
5
Tyre inflation pressure indicator
6
Air release valve
7
ON and OFF switch
8
12 volt cable connector
9
Tyre inflator bottle with sealing agent
10
Replacement valve core
11
The valve remover has a slot at its lower end which fits into the valve core.
1
This is the only way in which you can remove and re-install the valve core from
the tyre valve. The same also applies to the replacement valve core
Preparations for using the breakdown kit

Read and observe on page 205 first.
The following preparatory work must be carried out before using the break-
down kit.
›
Park the vehicle as far away as possible from the flow of traffic. Park on as
flat and firm a surface as possible.
›
If you are in flowing traffic, switch on the hazard warning light system and
set up the warning triangle at the prescribed distance! The national legal re-
quirements must be observed.
›
Have all the occupants get out. The passengers should not stand on the
road (instead they should remain behind a crash barrier, for instance) while
the wheel is being changed.
›
Switch off the engine and move the gearshift lever into Neutral or move the
selector lever on the automatic gearbox into position P.
›
Apply the handbrake firmly.
›
Check that you can carry out the repairs with the breakdown kit
Uncouple a trailer.
›
Remove the breakdown kit from the boot.
›
Stick the sticker » Fig. 181 on page 205 on the dashboard in the driver's
2
field of view.
» Fig. 181
» page
Emergency equipment and self-help
.
11
204.

205