Skoda Superb 2014 Owner's Manual page 138

Electronic immobilizer

Read and observe and
An electronic chip is integrated in the head of the key. The immobiliser is deac-
tivated with the aid of this chip when the key is inserted in the ignition lock.
The electronic immobiliser is automatically activated when the ignition key is
withdrawn from the lock.
The engine will not start if a non-authorized ignition key is used.
The following message is shown in the information cluster display.
Immobilizer active.

IMMOBILISER

Ignition Switch

Read and observe and
Petrol engines » Fig. 133
Ignition switched off, engine off, the steering can be locked
1
Ignition switched on
2
Starting engine
3
Diesel engines » Fig. 133
Fuel supply interrupted, ignition switched off, engine switched off, the
1
steering can be locked.
Heating glow plugs on, ignition switched on
2
Starting engine
3
To lock the steering, with the ignition key withdrawn, turn the steering wheel
until the steering locking pin engages audibly.
136
Driving
on page 135 first.
Fig. 133
Positions of the vehicle key in
the ignition lock
on page 135 first.
If the steering is locked and the key cannot be turned or can only be turned
with difficulty to position » Fig.
2
and the steering lock will unlock.
Note
We recommend locking the steering wheel whenever leaving the vehicle. This
acts as a deterrent against the attempted theft of your car.
Starting the engine

Read and observe and
Vehicles with a diesel engine are equipped with a glow plug system. The glow
plug warning light lights up after the ignition has been switched on. Start

the engine once the warning light has gone out.

You should not switch on any major electrical components during the heating
period otherwise the vehicle battery will be drained unnecessarily.
Procedure for starting the engine
›
Firmly apply the handbrake.
›
Move the gearshift lever into neutral or move the selector lever into position
P or N.
›
Switch on the ignition » Fig. 133
2
›
Depress and hold the clutch pedal (vehicles with a manual gearbox) or brake
pedal (vehicles with an automatic gearbox) until the engine starts.
›
Turn the key into position to the stop and release immediately after the
3
engine has been started – do not apply the accelerator.
After letting go, the vehicle key will return to position
If the engine does not start within 10 seconds, turn the key to position
peat the start-up process after approx. half a minute.
Vehicles with manual transmission
The engine will not start if the clutch pedal is not depressed.
The following message is shown in the information cluster display.
Depress clutch to start!

CLUTCH

133, move the steering wheel back and forth
on page 135 first.
on page 136.
.
2
. Re-
1
