Table of Contents
Advertisement
Each time the telephone has established a new connection with the hands-
free system, an update of the relevant phone book is performed. The updating
can take a few minutes. During this period, the available phone book is the one
stored at the previous update. Newly stored telephone numbers are only
shown after the updating has ended.
The update is interrupted if a telephone event (e.g. incoming or outgoing call,
voice control dialogue) occurs during the updating procedure. After the tele-
phone event has ended, the updating starts anew.
GSM II
The internal phonebook provides 2 500 free memory locations. Each contact
can contain up to 4 numbers.
On vehicles fitted with the Columbus navigation system, a maximum of 1 200
telephone contacts are shown on the display of this appliance.
If the number of contacts loaded exceeds 2 500, the phone book is not com-
plete.
GSM III
The internal phonebook provides 2 000 free memory locations. Each contact
can contain up to 5 numbers.
On vehicles fitted with the Columbus navigation system, a maximum of 1 000
telephone contacts are shown on the display of this appliance.
If the mobile phone's telephone book has more than 2,000 contacts, the fol-
lowing message will appear in the MAXI DOTdisplay:
Phone book not fully loaded
Universal telephone preinstallation GSM II
Introduction
This chapter contains information on the following subjects:
Connecting the mobile phone to the hands-free system
Telephone operation in the MAXI DOT display
®
1)
Depending on the Bluetooth
version on the mobile phone, an automatically generated 6-digit PIN (SSP)
is either displayed, or the PIN 1234 has to be entered manually.
2)
Some mobile phones have a menu, in which the authorisation for establishing a Bluetooth
is completed by inputting a code. If the authorisation input is required, it must always be performed
when re-establishing the Bluetooth connection.
122
Operation
The universal telephone preinstallation GSM II comprises the following func-
tions.
›
Phone Phonebook
›
Convenience operation of the telephone via the multifunction steering
wheel
» page
120.
›
Telephone operation in the MAXI DOT display
›
Voice control of the telephone
›
Music playback from the telephone or other multimedia units
All communication between a mobile phone and your vehicle's hands-free sys-
tem is established with the help of Bluetooth
Note
The following guidelines must be observed
two-way radio systems.
Connecting the mobile phone to the hands-free system
To connect a mobile phone with the hands-free system, the two devices must
be paired. Detailed information on this is provided in the operating instructions
for your mobile phone.
The following steps must be carried out for the connection.
›
Activate Bluetooth
phone.
›
Switch on the ignition.
›
Select the Phone - New user menu in the MAXI DOT display and wait until
the hands-free system has completed the search.
›
Select the phone you wish to connect from the list of units found.
›
Confirm the PIN
›
If the hands-free system announces (as standard SKODA_BT) on the display
of the mobile phone, enter the PIN
connection is established
›
To finish pairing in the MAXI DOT display, confirm the creation of the new
user profile.
122
123
®
connection
» page
121.
» page
» page
129.
®
technology.
» page
®
and the visibility of your mobile phone on your tele-
.
1)
within 30 seconds and wait, until the
1 )
.
2)
120.
» page
131.
119, Mobile phones and
Advertisement
Chapters
Table of Contents
