Skoda Superb 2014 Owner's Manual page 44

Note
In certain national versions the displays appear in the Imperial system of
■
measures.
If the display of the second speed is activated in mph, the current speed is
■
not indicated in km/h on the display.
The amount of fuel consumed will not be indicated.
■
Memory
Fig. 28
Multi-function display - memory display

Read and observe and
The multifunction display is equipped with two automatic memories, 1 and 2.
Display of the selected memory in the display at the position
Single-trip memory

Total trip memory

Select memory
›
Select the corresponding element of the multifunction display
Confirm the element again to switch between the individual memories.
Reseting
›
Select the corresponding element of the multifunction display
›
Select the desired memory.
›
Press and hold button or adjustment wheel
B
Single-trip memory (memory 1)
The single-trip memory collates the driving information from the moment the
ignition is switched on until it is switched off.
New data will also flow into the calculation of the current driving information if
the trip is continued within 2 hours after switching off the ignition.
42
Operation
on page 41 first.
A
» page
» page
» Fig. 26 on page 40.
D
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
Total-trip memory (memory 2)
The total trip memory collates the data from any number of individual trips up
to a total of 19 hours and 59 minutes or a 1999 km distance or, for vehicles
with a MAXI DOT display, 99 hours and 59 minutes, or a 9999 km distance.
The memory is deleted when either of these limits is reached and the calcula-
tion starts all over again.
Unlike the single-trip memory, the total-trip memory is not deleted after a pe-
riod of interruption of driving of 2 hours.
The following values of the selected memory are set to zero.
›
Average fuel consumption.
›
Distance driven.
›
Average speed.
›
Driving time
Note
Disconnecting the vehicle battery will delete all memory data.
Information overview
» Fig. 28 .

Read and observe
Outside temperature
The current outside temperature is displayed.
For vehicles with a MAXI DOT display this information is always shown.
42.
Driving time
The time travelled since the memory was last erased is displayed.
If you want to measure the time travelled from a particular moment in time on,
42.
at this moment, reset the memory by setting the button to zero
Memory.
The maximum time indicated in both memories is 19 hours and 59 minutes and
on vehicles which are fitted with a MAXI DOT display, it is 99 hours and 59 mi-
nutes. The indicator is set back to zero if this period is exceeded.
and on page 41 first.
» page 42,
