Table of Contents
Advertisement
9 SDI Rec Trigger
For setting whether to superimpose trigger signals
in tandem with the [SDI OUT] terminal as well as
the [REC] button on the camera body.
If "On" is specified, it is possible to record on a
device equipped with SDI record trigger in tandem
with the operation of the [REC] button.
When a compatible device is connected,
recording/stop control signals are output in tandem
with the operation of the [REC] button.
The SDI record trigger output status to the
connected device is indicated by REC B/STBY B
on the display screen.
[Setting Values: On, ROff]
Memo :
Even if REC B/STBYB is displayed on the
0
display screen, the compatible device may not
necessarily be recording.
SD Aspect
For setting the style of displaying images with a
16:9 aspect ratio on a 4:3 aspect ratio screen.
Letter:
0
Displays as a wide image with the top and
bottom blackened.
Squeeze:
0
Displays image that is squeezed horizontally.
[Setting Values: Letter, RSqueeze]
Memo :
When [Record Format] B [System] is set to
0
"SD", and [Record Format] B [SD Aspect] is set
to "4:3", "---" is displayed and selection is
disabled.
(A P116 [ System ] )
SD Set Up
For selecting whether to add a setup signal to the
video signal output from the [AV] output terminal.
Setup signals are added when "7.5%" is selected.
[Setting Values: 7.5%, 0.0%]
(Default values: 7.5% (U model), fixed at "0.0%" (E
model))
Memo :
Depending on the menu settings of the camera
0
recorder and the condition of the cable
connected to it, the setup signal setting may be
fixed at "0.0%". "0.0%" is displayed in gray in this
case.
Audio Set Item
CH1 INT
For selecting either the built-in microphone or the
[AUX] terminal as the CH1 audio input signal.
This item is selectable if the [CH-1] audio input
signal selection switch is set to "INT" O, and a
microphone is connected to the [AUX] terminal.
Int. Mic L:
0
Sets the left channel (Lch) of the built-in
microphone as the CH1 audio input signal.
AUX L:
0
Sets the [AUX] terminal as the CH1 audio input
signal.
[Setting Values: Int. Mic L, RAUX L]
Memo :
If the [AUX] terminal is not connected, this item
0
is fixed at "Int. Mic L".
When the [CH-1] audio input signal selection
0
switch is set to a value other than "INT", "---" is
displayed and selection is disabled.
If the handle unit is not connected, the state of
0
the [CH-1] audio input signal selection switch is
equivalent to "INT".
111
A/V Set Menu
Advertisement
Table of Contents
