Table of Contents
Advertisement
2 Select the scan range using the J/K buttons.
The scan range when the size of the imaging
0
device is set to "100% (Super35)" is displayed
as percentage.
.
Square frame
Round dotted frame : The image frame of the
Set in such a way that the vignette effect does
0
not spread into the round dotted frame.
3 Press the [LOLUX/3] button to check the
brightness.
The brightness confirmation screen is
0
displayed, and the scan range specified is
displayed in full screen size.
You can check the vignette effect through the
0
brightness displayed at the four corners and the
center of the brightness confirmation screen.
It is preferable to get 100 % brightness at the
four corners with respect to the 100 %
brightness at the center. However, depending
on the characteristic of the lens attached,
besides the vignette effect you may also not get
100 % brightness at the four corners.
97%
97%
100%
100%
98%
98%
.
: Scan range
lens equivalent to the
scan range (square
frame).
94%
94%
96%
96%
Memo :
When [Main Menu] B [System] B [Record Set] B
0
[Record Format] B [System] is set to "SD", and [SD
Aspect] is set to "4:3", the brightness confirmation
screen is not displayed. The scan range specified
is displayed in full screen and the item for setting
the scan range appears as a scrolling list on the
screen.
The values for the brightness at the four corners
0
are estimates. We recommend using a measuring
instrument to obtain accurate measurements.
While the brightness is displayed, you can use
0
the J/K buttons to change the scan range.
If you press the [LOLUX/3] button again, the item
0
for setting the scan range appears as a scrolling
list on the brightness confirmation screen.
97%
97%
98%
98%
.
Press the [LOLUX/3] button once again to return
0
to the scan range selection screen (initial
screen).
4 Press the Set button (R).
Variable Scan Mapping (VSM)
94%
94%
96%
96%
49
Advertisement
Table of Contents
