Table of Contents
Advertisement
Estimated Charging and Continuous
Operating Times
o Charging time
SSL-JVC50 (accessory) : Approx. 4 hrs
* When the [POWER ON/OFF] switch is set to "OFF"
Memo :
If you charge the battery immediately after using
0
while the battery is still warm, it may not be fully
charged.
For details, refer to the "INSTRUCTIONS" of the
0
battery.
o Continuous operating time
SSL-JVC50 (accessory) : Approx. 3 hrs 45 mins
*1
When [System] is set to "4K" and all other
settings are in factory default (excluding the
lens)
*2
When [System] is set to "HD" and all other
settings are in factory default (excluding the
lens)
Memo :
Actual operating times may differ depending on
0
the age of the battery, charging condition, and
operating environment.
Operating time is shortened in cold
0
environment.
The operating time may shorten when power
0
zoom is used, accessories are connected, or
when the LCD monitor is frequently used.
For purchase of spare batteries and battery
0
charger, please contact the local dealers in your
area.
Precautions for Batteries
Store the battery in a cool and dry place when
0
not in use. Do not expose the battery to high
temperatures (such as in a car under direct
sunlight). Failure to do so not only shortens the
battery life but also damages the battery.
If the operating time shortens drastically even
0
after charging, the battery may be reaching the
end of its life. Replace the battery with a new
one.
(*1)
Approx. 4 hrs (*2)
Using AC Power (DC IN Power)
Use the supplied AC adapter to operate the camera
recorder with AC power.
2
.
1 Connect the DC cable of the AC adapter to
the [DC] terminal of the camera recorder.
Check that the power switch of the camera
0
recorder is set to "OFF".
Open the cover of the [DC] terminal and
0
connect as shown in the diagram.
2 Hold down the lock button (blue) at the
center of the [POWER ON/OFF] switch to set
to "ON".
Power will be supplied to the camera recorder.
Caution :
Do not insert or remove the DC cable during
0
recording.
Do not use power supply of high voltage
0
fluctuation, containing noise such as ripple, or
with insufficient capacity.
Charging the Built-In Battery
The date/time and time code data are stored
0
using the built-in rechargeable battery.
When power is connected to the camera
0
recorder, the built-in battery always gets
charged. When the power is disconnected, the
battery gradually discharges.
The battery will be totally discharged if left
0
unused for 3 months and the date/time and time
code data will be reset. When this happens, set
the [POWER ON/OFF] switch to "ON" to display
the [Initial Setting] screen, then set the date/
time.
(A P32 [Initial Settings] )
1
29
Power Supply
Advertisement
Table of Contents
