Table of Contents
Advertisement
CH2 INT
For selecting either the built-in microphone or the
[AUX] terminal as the CH2 audio input signal.
This item is selectable if the [CH-2] audio input
signal selection switch is set to "INT" O, and a
microphone is connected to the [AUX] terminal.
Int. Mic R:
0
Sets the right channel (Rch) of the built-in
microphone as the CH2 audio input signal.
AUX R:
0
Sets the [AUX] terminal as the CH2 audio input
signal.
[Setting Values: Int. Mic R, RAUX R]
Memo :
If the [AUX] terminal is not connected, this item
0
is fixed at "Int. Mic R".
When the [CH-2] audio input signal selection
0
switch is set to a value other than "INT", "---" is
displayed and selection is disabled.
If the handle unit is not connected, the state of
0
the [CH-2] audio input signal selection switch is
equivalent to "INT".
Input1 Mic Ref./Input2 Mic Ref.
For setting the reference input level when the
[AUDIO INPUT INPUT1]/[AUDIO INPUT INPUT2]
selection switch is set to "MIC" or "MIC+48V".
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB, -32dB]
Memo :
This item is not displayed if the handle unit is not
0
connected.
Ref. Level
For setting the recording reference level. (Applies
to both [CH1/CH2].)
[Setting Values: -12dB, -18dB, R-20dB]
112
A/V Set Menu
XLR Manual Level
For setting whether to link manual audio
adjustment operation between [AUDIO INPUT
INPUT1] and [AUDIO INPUT INPUT2] terminals.
Select "Link" to link or "Separate" to separate.
When this item is set to "Link", adjust the recording
level using the [CH-1] recording level adjustment
knob.
[Setting Values: Link, RSeparate]
Memo :
This item is not displayed if the handle unit is not
0
connected.
Enabled only when both the [AUDIO INPUT
0
INPUT1/INPUT2] input terminals are set to
"LINE" or "MIC", and both [CH-1]/[CH-2] of the
[AUDIO SELECT CH-1/CH-2 AUTO/MANU]
switches are set to "MANU".
If any of the [AUDIO INPUT INPUT1/INPUT2]
0
input terminals is set to "INT", and [LEVEL
MODE] is set to "AUTO", this item is fixed at
"Separate".
When this item is set to "Link", [CH-2] recording
0
level adjustment knob is disabled.
Audio Level
Select this item to switch to the audio level
adjustment screen.
(A P68 [Setting the Audio recording Level in the
Main Menu] )
* The contents displayed on the screen vary
depending on the various settings.
Memo :
This item is not displayed if the handle unit is
0
connected.
When [Audio On FULL AUTO] is set to "Auto"
0
and the [AUTO MODE FULL/PRESET/OFF]
switch is set to "FULL", the audio recording level
cannot be selected.
If both CH1 and CH2 are set to the built-in
0
microphone or to AUX, settings for CH2 will not
be displayed, and the settings for CH1 will apply
to CH2.
Limiter Mode
For setting whether to link the limiter operation of
[CH-1] and [CH-2].
Select "Link" to link or "Separate" to separate.
[Setting Values: Link, RSeparate]
Advertisement
Table of Contents
