Table of Contents
Advertisement
wDr Setup
You can set to display a sharp image of the objects in a scene where both bright and dark
areas exist.
1. Select <Backlight>.
2. Set <mode> to <wDr>.
3. Select each item and set it properly.
• WDR Limit : Specify the WDR
sensitivity level.
If WDR mode is active, the shutter mode
`
M
cannot be changed. Data transfer via the
network is available at up to 15 fps.
If the WDR mode is active, a moving
`
object can cause an afterimage on the
screen.
If you select WDR, you may encounter the following problems. So set it to Not Used.
`
J
-
Unnatural change of colors that cause an unnatural image on the screen
-
Noise on the bright area of the image
As the performance of the WDR function may differ depending on the bright-area size of the
`
image, it is recommended to optimize the installation angle for the best performance.
At night operation, this function will be activated only if the incoming highlight exceeds a certain
`
area in a low contrast environment.
Increasing the maximum value may cause an unnatural portion of the image.
`
For the best WDR performance, it is recommended to set the Iris mode to <Auto>.
`
Since the auto focus operation can be repeated depending on the lighting condition if user
`
backlight compensation is used, it is recommended to use the focusing mode of <One Push AF>
or <Manual>.
SSDR and shutter cannot be used in WDR mode.
`
English _85
Hide quick links:
Advertisement
Table of Contents
