Table of Contents
Advertisement
B
C
5. Place the column assembly (C) Fig. 18, on top of the
column extension (A) and align the four holes (B) in the
column assembly with the four holes in the column
extension (A).
6. Place a flat washer that was removed in STEP 2, on
an M8x1.25x80mm hex head screw.
7. Insert the screw through the hole in the column
assembly (C) Fig. 19, column extension (A), and thread into
base (B). Repeat this process for the three remaining
holes.
8. Replace the rack cover bracket (D) Fig. 19, that was
removed in STEP 1.
9. Loosen the holddown knob (B) Fig. 19A and remove
the hold down. Loosen set screw (C) and removed
holddown rod (A) and replace with the extended hold
down rod. Tighten set screw (C). Place the hold down (B)
on the hold down rod and tighten hold down handle (B).
NOTE: REVERSE THE PREVIOUS PROCEDURE
("ASSEMBLING COLUMN EXTENSION") TO REMOVE
THE COLUMN EXTENSION.
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING
MORTISER
The power switch is located on the left side of the
mortiser. To turn the mortiser "ON", press the green start
button (A) Fig. 20. To stop the mortiser, push the red
button (B).
LOCKING SWITCH IN
THE "OFF" POSITION
When the tool is not in use, the switch should be locked
in the "OFF" position to prevent unauthorized use. This
can be done by inserting the lockout pin (C) Fig. 21,
Delta accessory model number 50-164, through the hole
in the start button (A). Place the 1/8" shank of a lock
through the hole in the lockout pin and secure the lock
as shown.
A
Fig. 18
B
B
C
A
B
C
A
11
D
Fig. 19
A
C
Fig. 19A
Fig. 20
Fig. 21
A
B
Hide quick links:
Advertisement
Table of Contents
