Operating Controls And Adjustments; On/Off Switch; Locking Switch In The "Off" Position - Delta ShopMaster MM300 Instruction Manual

OPERATING CONTROLS AND ADJUSTMENTS

ON-OFF SWITCH
The switch (A) Fig. 26, is located on the side of the
motor. To turn the machine "ON", move the switch (A),
up to the "ON" position. To turn the machine "OFF",
move the switch down to the "OFF" position.
LOCKING SWITCH IN
THE "OFF" POSITION
When the tool is not in use, the switch should be locked
in the "OFF" position to prevent unauthorized use. This
can be done by grasping the switch toggle (B) Fig. 27,
and pulling it out of the switch, as shown. With the
switch toggle (B) removed, the switch will not operate.
However, should the switch toggle be removed while the
machine is running, the switch can be turned "OFF"
once, but cannot be restarted without inserting the
switch toggle (B).
RAISING AND
LOWERING THE HEAD
The head (A) Fig. 28, is raised and lowered by means of
the lever (B). For maximum leverage during the mortising
operation, the lever (B) can be repositioned by pulling
out the hub (C) of the lever assembly and repositioning
hub on the pinion shaft.
A
B
A
12
Fig. 26
Fig. 27
B
C
Fig. 28