Operating Controls And Adjustments; Locking Switch In The "Off" Position - Delta 37-380 Instruction Manual

8" professional jointer
Table of Contents

Advertisement

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING
JOINTER
1. The on/off switch is located underneath the switch
shield (B) Fig. 31. To start the jointer, move switch (A) up
to the "ON" position.
2. To turn the jointer "OFF", push down on switch
shield (B) Fig. 32, as shown.
LOCKING SWITCH
IN THE "OFF" POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the "OFF" position to prevent
unauthorized use. Insert the shank of padlock (C) Fig.
33, through the holes in the switch plate to lock the
on/off switch trigger (A).
INFEED TABLE
ADJUSTMENTS
1. To raise or lower the infeed table, loosen table
locking handle (A) Fig. 34, which is located at the rear of
the infeed table and loosen locking handle (B) Fig. 35,
which is located at the front of the infeed table.
B
A
B
C
A
14
Fig. 31
Fig. 32
Fig. 33
A
Fig. 34

Advertisement

Table of Contents
loading

Table of Contents