Mounting The Switch Assembly - RIDGID R4512 Operator's Manual

ASSEMBLY
Lay a framing square on each side of the table top as

shown to make sure the table extensions are level with
the top.
If the table extensions and rails are flat and level, securely

tighten the four center nuts on the front rail and the four
center bolts on the rear rail.
Securely tighten the four outer nuts and bolts on each

rail.
Check the table and extensions to make sure all

assembled parts are flush and level.
If the table extensions, rip fence, and rails are not level,

make adjustments by slightly loosening and retightening
the bolts and nuts, and repositioning the rails until they
are level and flush with the table top.
INSTALLING THE SPREAdER BAR
See Figure 33.
The bolts and nuts for the spreader bar were removed from
the large fastener pack during installation of the rails.
Position the spreader bar at the end of the rails with the

tabs facing away from the saw table.
Slide a hex head bolt into the groove on the front rail and

insert the bolt through the tab in the spreader bar. Thread
two hex nuts over the bolt and finger tighten.
Insert a bolt through the holes in the rear rail and spreader

bar tab.
Thread two hex nuts onto the bolt.

Using a 13 mm wrench, securely tighten all bolts.


MoUNTING THE SwITCH ASSEMBLY

See Figure 34.
Take the following from the large fastener pack:

2 hex head bolts (6 x 14 mm)
2 lock washers (6 mm)
2 hex nuts (6 mm)
Slide two hex head bolts into the middle groove in the

front rail.
Insert the bolts through the holes in the switch assembly

mounting plate.
Thread a lock washer and nut over each of the bolts.

Securely tighten the hex nuts using a 10 mm wrench.

framING square
heX heaD
bOlt
heX heaD
bOlt
lOcK
washer
Nut
25
bOlt
sPreaDer
bar
tab
swItch
assembly
Fig. 32
Nut
Fig. 33
Fig. 34