PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 4 REMCS Service Operations
1. From the menu in the window shown in
change].
The [Connection type change] window (shown in
configuration) appears.
2. After changing the connection configuration, click the [Next] button.
The current setting information is discarded and the machine status becomes [Setting not completed]. You
need to perform the service start procedure by specifying the connection information again according to
Setting the connection
FIGURE 4.6 Window for changing the active connection configuration
4.2.7
Displaying the certificate
Use the following procedure to confirm the information of the certificate.
1. From the menu in the window shown in
The window shown in
4.8 [Display of certificate] window (during use of certificate that has been replaced)
- Window displayed when the certificate has not been replaced
FIGURE 4.1 [REMCS initial]
configuration.
FIGURE 4.1 [REMCS initial]
FIGURE 4.7 [Display of certificate] window (with certificate not replaced)
window, click [Connection type
FIGURE 4.6 Window for changing the active connection
window, click [Display of certificate].
38
3.2.2
or
FIGURE
appears.
C122-E120-06EN