Fujitsu PRIMEQUEST 1000 Series Installation Manual page 85

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 6 REMCS Messages
Message code
RMG_0015 Invalid entry.
RMG_0018 Failed to get registration data.(xxx)
RMG_0028 Input all entries.
RMG_0037 Execute registration of REMCS environment data.
Are you sure?
RMG_0041 Failed to setting Machine status.(xxx)
RMG_0056 Failed in the connection check notification. (xxx)
RMG_0079 Point-to-Point Connection environment setting frame
display completed.
RMG_0080 Failed to set REMCS environment(Point-to-Point).
(xxx)
RMG_0081 Registration of REMCS environment data (Point-to-
Point) completed.
RMG_0095 Connection type mismatch.
RMG_0181 Invalid E-mail address specified.
RMG_0189
Execute registration of REMCS environment
data.After this operation, all events are not sent to the
REMCS Center until connection check is completed.
\nAre you sure?
Message
65
Action
solved, contact the support
center.
Correct the entered value.
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
Fill in any blank entries.
Click the [OK] or [Cancel]
button.
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
Check whether the network
status is normal.
None.
Confirm the FQDN or IP address
of the specified SMTP server.
Also check whether the network
status is normal.
None.
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
Enter a valid value.
Click the [OK] or [Cancel]
button.
C122-E120-06EN