Figure 3.6 [Point-To-Point Connection Environment Settings] Window; Table 3.2 Input Items For The [Point-To-Point Connection Environment Settings] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 3 REMCS Service Start Procedure
Item
Encryption type
2. Click the [Next] button.
After the connection configuration is registered, the window shown in
settings] window appears.
When the connection configuration is [P-P Connection(ISDN: Mail Only)] or [P-P Connection(VPN:
Mail Only)]
If you selected [P-P Connection(ISDN: Mail Only)] or [P-P Connection(VPN: Mail Only)] in the window shown
in FIGURE 3.4 [Initial Settings]
environment settings] window
After setting the REMCS service, you can still change the connection information by clicking [Connection
Environment] from the menu in the window shown in

FIGURE 3.6 [Point-to-Point Connection environment settings] window

1. Enter the values for the following items.

TABLE 3.2 Input items for the [Point-to-Point Connection environment settings] window

Item
SMTP/PROXY Server
Sender E-mail Address
Division method
If the S/MIME format is not supported before the firmware update, the
initial value is [Previous encryption]. The initial value at the firmware
update time is the setting before the firmware update.
window, the window shown in
appears.
FIGURE 4.1 [REMCS initial]
Enter the SMTP/PROXY server name or IP address in single-byte
alphanumeric characters and symbols.
Enter the sender e-mail address in single-byte alphanumeric characters and
symbols.
Select the division method from [No division], [Mail division], and [Event
division]. The initial value is [Event division].
18
Description
FIGURE 3.7 [Periodical Connection
FIGURE 3.6 [Point-to-Point Connection
window.
Description
C122-E120-06EN