Fujitsu PRIMEQUEST 1000 Series Installation Manual page 33

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 3 REMCS Service Start Procedure
- IP address or FQDN of the mail server to be used
You can specify the FQDN only when using an Internet connection through the user port.
If you specify an FQDN, confirm that a DNS server is specified in [Network] - [Network Interface] of the
MMB Web-UI.
- Sender e-mail address (with permission to send external e-mails)
- Whether to enable the mail server for partitioned e-mail sending
Confirm whether your mail server is enabled for partitioned e-mail sending.
To connect to the REMCS Center through the REMCS port, you first need to set the Maintenance Port in
[Network] - [Network Interface] of the MMB Web-GUI. Before making the port settings, prepare such
information as the IP address to be assigned, subnet mask, gateway address, and destination SMTP server
address.
You can also set the IP address of the REMCS port by using the following CLI.
Set command: Sets the REMCS port.
set maintenance_ip <ip address> <netmask> <gateway address> <SMTP
address>
Note
You do not need to specify <gateway address> and <SMTP address> if you make point-to-point (P-P) REMCS
connections. In this case, specify 0.0.0.0 for both <gateway address> and <SMTP address>.
Display command: Displays the REMCS port settings.
show maintenance_ip
For details on the commands, see Chapter 2 MMB CLI (Command Line Interface) Operations in the PRIMEQUEST
1000 Series Tool Reference (C122-E110EN).
Note
Do not perform registration during the maintenance work.
13 C122-E120-06EN