Installing The Handlebar - Yamaha MBK YQ100 Service Manual

HANDLEBAR
EAS00673

INSTALLING THE HANDLEBAR

1.Stand the scooter on a level surface.
WARNING
Securely support the scooter so that there is
no danger of it falling over.
2.Install:
• handlebar
NOTE:
Install the handlebar onto the steering shaft
notch.
CAUTION:
• Before installing the handlebar, wipe off
any trace of oil from the inserted section of
the shaft with solvent.
• Insert the bolt from the left as shown.
3.Tighten:
• handlebar holder
Handlebar holder bolt
60 Nm (6.0 m • kg)
4.Fasten:
• wire harness
(to the handlebar bracket)
Refer to "CABLE ROUTING" in chapter 2.
5.Install:
• left handlebar switch
NOTE:
Align the projection on the left handlebar switch
with the hole in the handlebar.
6.Install:
• throttle cable
• throttle grip
NOTE:
• Lubricate the inside of the throttle grip with a
thin coat of lithium soap base grease and
install it onto the handlebar.
• Apply lithium soap base grease onto the cable
end and throttle cable support.
6-40
CHAS