Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha MBK YQ100 Service Manual

IMPORTANT INFORMATION
EAS00023
LOCK WASHERS / PLATES AND COTTER
PINS
1.After removal, replace all lock washers / plates
and cotter pins. After the bolt or nut has
been tightened to specification, bend the lock
tabs along a flat of the bolt or nut.
EAS00024

BEARINGS AND OIL SEALS

1.Install bearings and oil seals so that the
manufacturer's marks or numbers are visible.
When installing oil seals, lubricate the oil seal
lips with a light coat of lithium soap base
grease. Oil bearings liberally when installing,
if appropriate.
Bearing
CAUTION:
Do not spin the bearing with compressed air
because this will damage the bearing
surfaces.
Oil seal
EAS00025

CIRCLIPS

1.Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip
sharp-edged corner
the thrust
Shaft
1-3
GEN
INFO
, make sure the
is positioned opposite
that the circlip receives.