Installing The Handlebar - Yamaha XP500 2001 Service Manual

HANDLEBAR
EAS00671

INSTALLING THE HANDLEBAR

1. Stand the scooter on a level surface.
WARNING
Securely support the scooter so that there is
no danger of it falling over.
2. Install:
S handlebar 1
S handlebar upper holders 2
WARNING
S First, tighten the bolts on the front side of
the handlebar holder, then on the rear side.
S Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
NOTE:
S The upper handlebar holders should be
installed with the arrows a facing forward A .
S Align the match marks b on the handlebar
with the upper surface of the lower handlebar
holders.
3. Install:
S front brake master cylinder 1
S front brake master cylinder holder 2
S holder bolt
NOTE:
S Install the front brake master cylinder holder
with the "UP" a mark facing up.
4-59
CHAS
23 Nm (2.3 mSkg)
10 Nm (1.0 mSkg)