D-Link NetDefend DFL-210 Cli Reference Manual page 145

3.38.1. OSPFArea
For point-to-point and point-to-multipoint networks, specify the IP addresses of directly connected
routers.
Properties
Interface
IPAddress
Metric
Comments
3.38.1.3. OSPFAggregate
Description
An aggregate is used to replace any number of smaller networks belonging to the local (intra) area
with one contiguous network which may then be advertised or hidden.
Properties
Network
Advertise
Comments
3.38.1.4. OSPFVLink
Description
An area that does not have a direct connection to the backbone must have at least one area border
router with a virtual link to a backbone router, or to another router with a link to the backbone.
Properties
Name
RouterID
UseDefaultAuth
Specifies the OSPF interface of the neighbor.
IP Address of the neighbor.
Specifies the metric of the neighbor. (Optional)
Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be
placed last in the list and the Index will be equal to the length of the list.
The aggregate network used to combine several small routes.
Advertise the aggregate. (Default: Yes)
Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be
placed last in the list and the Index will be equal to the length of the list.
Specifies a symbolic name for the virtual link. (Identifier)
The ID of the router on the other side of the virtual link.
Use the authentication configuration specified in the OSPF process.
Chapter 3. Configuration Reference
145