D-Link NetDefend DFL-210 Cli Reference Manual page 161

3.48.1. Route
EnableHostMonitoring
Reachability
GracePeriod
ReachabilityCount
Network
Metric
ProxyARPAllInterfaces
ProxyARPInterfaces
Comments
3.48.1.1. MonitoredHost
Description
Specify a host and a monitoring method.
Properties
Method
IPAddress
Port
PollingInterval
ReachabilityRequired
Samples
MaxPollFails
MaxAverageLatency
Note
If no Index is specified when creating an instance of this type, the object will be
placed last in the list and the Index will be equal to the length of the list.
Monitoring method. (Default: ICMP)
Specifies the IP address of the host to monitor.
Specifies the TCP port to monitor.
Delay in milliseconds between each monitor attempt. (Default:
10000)
Specifies if this host is required to be reachable for monitoring to
be successful. (Default: No)
Specifies the number of attempts to use for statistical calculations.
(Default: 10)
Specifies the maximum number of failed attempts until host is
considered to be unreachable. (Default: 2)
Specifies the max average latency for the sample attempts.
(Default: 800)
1000)
Enables the Host Monitoring functionality. (Default: No)
Specifies the number of hosts that are required to be reach-
able to consider the route to be active. (Default: ALL)
Specifies the time to wait after a reconfiguration until the
monitoring begins. (Default: 5)
Minimum number of reachable hosts to consider the route to
be active.
Specifies the network address for this route.
Specifies the metric for this route. (Default: 0)
Always select all interfaces, including new ones, for publish-
ing routes via Proxy ARP. (Default: No)
Specifies the interfaces on which the security gateway should
publish routes via Proxy ARP. (Optional)
Text describing the current object. (Optional)
161
Chapter 3. Configuration Reference