L2Tpclient - D-Link NetDefend DFL-210 Cli Reference Manual

3.28.6. L2TPClient

SetupSAPer
DeadPeerDetection
NATTraversal
KeepAlive
KeepAliveSourceIP
KeepAliveDestinationIP
Metric
AutoInterfaceNetworkRoute
Comments
3.28.6. L2TPClient
Description
A PPTP/L2TP client interface is a PPP (Point-to-Point Protocol) tunnel over an existing IP network.
Its IP address and DNS servers are dynamically assigned.
Properties
Name
IP
Network
RemoteEndpoint
TunnelProtocol
OriginatorIPType
OriginatorIP
DNS1
DNS2
Username
Password
Setup security association per network, host or port. (Default:
Net)
Enable Dead Peer Detection. (Default: Yes)
Enable or disable NAT traversal. (Default: OnIfNeeded)
Disabled, Auto or Manual. (Default: Disabled)
Source IP address used when sending keep-alive ICMP pings.
Destination IP address used when sending keep-alive ICMP
pings.
Specifies the metric for the auto-created route. (Default: 90)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
The host name to store the assigned IP address in, if this net-
work object exists and have a value other then 0.0.0.0 the
PPTP/L2TP client will try to get that one from the PPTP/
L2TP server as preferred IP. (Optional)
The network from which traffic should be routed into the tun-
nel.
The IP address of the L2TP/PPTP server.
Specifies if PPTP or L2TP should be used for this tunnel.
(Default: PPTP)
Specifies what IP address to use as source IP in e.g. NAT.
(Default: LocalInterface)
Manually specified originator IP address to use as source IP
in e.g. NAT.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPTP/L2TP interface.
The password to use for this PPTP/L2TP interface.
124
Chapter 3. Configuration Reference