L2Tpclient - D-Link NetDefend DFL-210 Cli Reference Manual

3.30.6. L2TPClient

3.30.6. L2TPClient
Description
A PPTP/L2TP client interface is a PPP (Point-to-Point Protocol) tunnel over an existing IP network.
Its IP address and DNS servers are dynamically assigned.
Properties
Name
IP
Network
RemoteEndpoint
TunnelProtocol
OriginatorIPType
OriginatorIP
DNS1
DNS2
Username
Password
PPPAuthNoAuth
PPPAuthPAP
PPPAuthCHAP
PPPAuthMSCHAP
PPPAuthMSCHAPv2
MPPENone
MPPERC440
MPPERC456
Specifies a symbolic name for the interface. (Identifier)
The host name to store the assigned IP address in, if this net-
work object exists and have a value other then 0.0.0.0 the
PPTP/L2TP client will try to get that one from the PPTP/
L2TP server as preferred IP. (Optional)
The network from which traffic should be routed into the tun-
nel.
The IP address of the L2TP/PPTP server.
Specifies if PPTP or L2TP should be used for this tunnel.
(Default: PPTP)
Specifies what IP address to use as source IP in e.g. NAT.
(Default: LocalInterface)
Manually specified originator IP address to use as source IP
in e.g. NAT.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPTP/L2TP interface.
The password to use for this PPTP/L2TP interface.
Allow no authentication for this tunnel. (Default: No)
Use PAP authentication protocol for this tunnel. User name
and password are sent in plaintext. (Default: Yes)
Use CHAP authentication protocol for this tunnel. (Default:
Yes)
Use MS-CHAP authentication protocol for this tunnel.
(Default: Yes)
Use MS-CHAP v2 authentication protocol for this tunnel.
(Default: Yes)
Allow authentication without Microsoft Point-to-Point En-
cryption (MPPE). (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
139
Chapter 3. Configuration Reference