Sdi Molex Connector; Tip And Ring Posts; Super Capacitor - Bosch D9412GV2 Operation And Installation Manual

.
Table 3: Compatible Accessories (continued)
Model Title
D1255W Text Keypad (white)
D1256 Fire Keypad (Command Center)
D1257 Fire Alarm Annunciator
1
D1260/D1260B Keypads
D1640 16.5 VAC 40 VA Transformer
D8004 Transformer Enclosure
D8125 POPEX Module
D8125MUX Multiplex Bus Interface
2
ISW-D8125CW Commercial Wireless Interface Module
2
D8125INV Inovonics Wireless Interface Module
D8128D OctoPOPIT Module
D8129 OctoRelay Module
D8130 Release Module
D8132 Battery Charger Module
D9127U/T POPIT Module
D9131A Parallel Printer Interface Module
D9210B Access Control Interface Module
ZX776Z PIR Motion Sensor [15 m (50 ft)] with POPIT
ZX794Z PIR Motion Sensor [24 m (80 ft)] with POPIT
ZX865
PIR/Microwave Motion Sensor [+1.7°C (+35°F)] with POPIT
ZX938Z PIR Motion Sensor [18 m (60 ft)] with POPIT
ZX970
PIR/Microwave Motion Sensor [+1.7°C (+35°F)] with POPIT
1
Version 1.03 or above
2
The ISW-D8125CW and the D8125INV were not investigated by UL. Do not use the ISW-D8125CW or D8125INV in UL Listed
installations.
3
Where the fire alarm transmitter is sharing on-premise communications equipment, the shared equipment must be UL Listed (ITE
or fire protective signaling).
3.3 Features in the D9412GV2 and
D7412GV2
3.3.1

SDI Molex Connector

Use the SDI Molex Connector to connect easily an
SDI device with the SDI bus, without needing to
disconnect wires connected to the SDI terminals.
Possible applications include:
•
Connecting a DX4010i to program the control
panel with Remote Programming Software (RPS)
at the premises
•
Connecting a keypad to test the control panel.
Bosch Security Systems, Inc. | 7/09 | F01U003641-04
D9412GV2/D7412GV2 | Operation and Installation Guide | 3.0
3
3.3.2
The tip and ring posts allow connecting a phone or
buttset for the purpose of troubleshooting
communications between the control panel and the
central station. This connection allows monitoring of
the dial tone, handshaking tones from the receiver,
and communications signals.
3.3.3
The D9412GV2 and D7412GV2 have a capacitor
called Super Cap. This component preserves the
parameters stored in the control panel's RAM chip
when the lithium battery is replaced. The Super Cap
can retain voltage for up to 30 minutes after the
lithium battery is removed.
UL 864 Fire
X
X
X
X
X
X
X
X
X
Do not connect the D5200 Programmer to
the SDI Molex connector.

Tip and Ring Posts

Super Capacitor

Overview
Intrusion
X X
X
X
X X
X X
X X
X X
X X
2
X
2
X
X X
X X
X X
X X
X X
X X
X X
X
X
X
X
11