Icom IC-M602 Instruction Manual page 38

6
DSC OPERATION
D D Transmitting Group call
The Group call function allows you to transmit a DSC signal
to a specific group only.
q Push [MENU] to enter the DSC menu.
w Rotate [CHANNEL] to select "Group Call," push
[ENT].
Select item
˘Individual Call
˘Group Call
˘All Ships Call
˘Position Request
˘Position Report
˘Polling Request
e Rotate [CHANNEL] to select the desired pre-programmed
group address or "Manual Input," push [ENT].
• The ID code for the group call can be set in advance. (p. 20)
• When "Manual Input" is selected, set the 8-digit ID code for
the group you wish to call with keypad.
Select Address
˘Manual Input
˘I-com
˘Osaka
˘Tokyo
˘
30
--DSC Menu--
--DSC Menu--
<CLR˘Exit / ENT˘OK>
r Rotate [CHANNEL] to select a desired intership channel
or "Manual Input," push [ENT].
• Intership channels are already preset into the transceiver in rec-
ommending order.
t Push [ENT] to transmit the group call.
• If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
--DSC Menu--
Group Call ready
<CLR˘Exit / ENT˘OK>
y After the group call has been transmitted, the following in-
dication is displayed.
--DSC Menu--
Group Call
TX Complete
<CLR˘Exit>
u Push [CLR] to exit the condition and selects the specified
intership channel in step r automatically.
• Even if [CLR] hasn't been pushed, the transceiver selects the
specified intership channel in step r automatically.