Fuser Removal - Lexmark X203n Servise Manual

Fuser removal

1.
Remove the paper exit guide assembly. See
more information.
2.
Remove the two screws (A) securing the fuser.
3.
Disconnect the thermistor cable at J10 and exit sensor at J8 on the controller card.
4.
Slide the fuser out far enough to expose and disconnect the AC cable connections.
5.
To disconnect the fuser power cables, slide the insulation (B) back to expose the connectors. Press the
tang (C) on the connector to disconnect the cable connector.
6.
Remove the fuser. Avoid damaging the insulation on the exit sensor and thermistor cables.
Note: Be sure to slide the insulation back in place after reconnecting the cables.
"Paper exit guide assembly removal" on page 4-37
A
B
7011-2xx / 3xx
C
Repair information
for
4-23