Lexmark X203n Servise Manual page 78

7011-2xx / 3xx
Step Action and questions
4 Properly connect the cables to the RIP board. Restart
the device into diagnostic mode.
Does the 900.xx error reoccur during startup?
5 Replace the RIP board, and restart the device.
Does this fix the problem?
Note: If an error, different from the original 900.xx, is
displayed, consult the service check for that error.
6 Print the following:
• Error log
• Menu settings page
• Network settings page
Does the 900.xx error reoccur while these pages
were printing?
7 Re-attach the communications cable. Restart the
printer to operating mode. Send the printer a print job.
Does the 900.xx error reoccur?
Note: Before performing this step, write down this
information about the file being sent to the printer:
• Application used
• Operating system
• Driver type
• File type (PCL, PostScript, XPS, etc.)
8 Restart the printer to operating mode. Send a different
print job to the device.
Does the 900.xx error reoccur?
9 Upgrade the firmware. Contact your next level of
support for the correct firmware level to use.
Restart the printer to operating mode. Send the printer
a print job.
Does the 900.xx error reoccur?
10
Is the device a Multi Function Printer?
11 Run a copy job.
Does the 900.xx error reoccur?
12 Run a scan to PC job.
Does the 900.xx error reoccur?
13 Is there optional memory installed?
14 Reinstall the memory, and send a print job to the
device.
Does the 900.xx error reoccur?
15 Install a Lexmark recommended memory option. Send
a print job to the device.
Does the 900.xx error reoccur?
16 Is there a modem installed on the device?
2-52
Service Manual
Yes No
Go to step 5. Go to step 6.
Problem Go to step 31.
resolved.
Go to step 31. Go to step 7.
Go to step 8. Go to step 10.
Go to step 9. Go to step 10.
Go to step 31. Go to step 10.
Go to step 11. Go to step 13.
Go to step 31. Go to step 12.
Go to step 31. Go to step 13.
Go to step 14. Go to step16.
Go to step 15. Go to step 16.
Go to step 31. Problem
resolved.
Go to step 17. Go to step 21.