Lexmark X203n Servise Manual page 42

7011-2xx / 3xx
Fax error log codes (Continued)
Error code
884
885
886
887
888
889
88A
901
902
903
904
905
906
907
908
A00
2-16
Service Manual
Description
Failure to transmit training successfully
in V29, V27 terminal modulation
schemes.
Failure to transmit training successfully
in V17terminal modulation scheme.
Failure to transmit training successfully
in V29 terminal modulation scheme.
Failure to transmit training successfully
in V27 terminal modulation scheme.
Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
Failed to connect at the minimum
speed supported by the MFP.
Failed to connect using V.34
modulation scheme.
No fax tones detected from remote
end.
No dial tone detected.
Busy tone detected.
Hardware error detected.
A timeout occurred after dialing the
number and waiting for a response.
Fax canceled by user.
Modem detected a digital line
connection.
Phone line was disconnected
Received request for unsupported
function from remote fax device.
Action
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send setting's.
• Adjust the "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Incompatible connection.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
• Check by enabling 'Behind a PABX'
setting.
• Check phone line.
• Check MFD modem hardware.
Check with remote end if successive
attempts fail.
See "Modem service check" on
page 2-29.
Check with remote end if successive
attempts fail.
No action needed.
Verify the MFP is connected to an analog
line. See"Fax transmission service
check" on page 2-45.
Restore phone line connection.
No action needed.