Non-Catastrophic Errors - Lexmark 4300 Series Service Manual

4421-XXX

Non-catastrophic errors

In this state, an error has occurred, but the All-In-One can continue to
operate. You may need to intervene using a button press, or the machine
may time out and return to the Error! Reference source not found state,
depending upon the error. The All-In-One will continue to accept and
respond to data until its buffers are full. In general, the entire device is in the
non-catastrophic error state, but only the logical device with the error
changes its behavior.
Non-catastrophic error list
Code Name
1003 Paper
Calibrate
Failure
1102 Incorrect
Printhead
1201 Print
Incomplete
2-4
Service Manual
Description
The DC paper feed
system fails to initialize
or calibrate.
The printhead ID is not
valid.
The print carrier
stopped before all of
the data was used.
Action
Unplug the All-In-One;
wait a few seconds,
then plug the
All-In-One back in and
turn the power on. If
the error remains,
check for voltage
(approximately 5 V dc)
on pin 2 of J15. If
okay, verify voltage at
the Encoder card as
well (same pin at
Encoder card end). If
there is no voltage at
J15-pin 2, replace the
system board. If there
is no voltage at the
Encoder card end, but
voltage is okay at J15,
replace the print
engine.
Replace the print
cartridge(s).
Resend the print job.