Canon opture 10 Instruction Manual page 39

Built-in speaker
o
When using the built-in speaker, make sure that
"0"
is not displayed on the
screen. When using the headphones, make sure that
"0"
is displayed. Change
the setting as necessary (OJ 70).
o
The built-in speaker does not sound when
"0"
is displayed.
o
Do not connect headphones unless
"0"
is displayed as it produces noise.
o
The built-in speaker is monaural. Use headphones for stereo sound.
o
The setting has to be done separately for each operating mode. Make sure to
change the setting when you have change the operating mode.
Adjusting the Volume
............................................................................................................................................................................
-
Turn the selector dial up to increase the volume, and
down to lower the volume.
• A volume bar appears for 4 seconds.
• You can turn off the volume completely by turning the selector
dial down until [OFF] appears. Turn the selector dial up to increase the volume again.
II
0 Sound may become distorted when the volume is turned up too high.
~~
..,... 0 The headphone volume can be adjusted in all operating modes.
o
The camcorder retains the setting even if you turn it off (separately for
headphones and built-in speaker).
o
See also Using Headphones during Recording (OJ 70).
39