Canon opture 10 Instruction Manual page 299

"lftheindicatorgoesintotheyeliowareaaslspeak,1
know the microphone will be adjusted properly Ifnotl
need to move the microphone closer"
Check if the microphone volume is correctly indicated and click
[Next].
• In TAPE CAMERA mode: Direct your voice • • • • • • • • • •
a
into the microphone of your camcorder
and check if the volume indicator
operates correctly.
• In TAPE PLAY (VCR) mode: Play back the
tape and check if the volume indicator
operates correctly.
• Sound input with the camcorder via
IEEE1394 connection cannot be adjusted
with the volume lever. The volume
indicator will not operate when the
camcorder is in CARD CAMERA mode.
9.
1 O.
Click [Finish].
• The settings for speaker and
microphone are complete.
You have now compleled the Audio and Video Tuning
Wizard
If you havelrouble with your camera, speakers, and
microphone in lhe fulure or if you change your audio
01
video setlings in another program, run this wizard again
Tociosethis wizard,c1ick Finish
There are two methods to start a videoconference. You can invite your contact or
you can accept an invitation from your contact.
A
Caution:
• An error message may appear and the communication may not work correctly.
In such case, reconfirm your setting in the [Audio Tuning Wizard] .
• Starting a Videoconference by Inviting a Contact
1.
On the DVM panel, click [Remote].
37