Skew; Quick Test - Lexmark C540n Service Manual

Description Value

Skew

-100 to +100
Each increment corresponds to
1/1200 of an inch.
The default is 0.
Print another copy of the Quick Test to verify your changes.
6.
7. Continue changing the settings by repeating steps 3 through 5.
To exit Registration, press Back (
Skew
One printhead houses the four color planes. The black plane is aligned to the printer, and the other color planes
are internally aligned to black. Electronic alignment fine tunes the alignment of the color planes to the black
plane once the printhead is installed. See
alignment. This must be performed before color skew adjustment is attempted. The following illustration shows
proper alignment versus skewed alignment.
Lexmark C544

Quick Test

Printer Information Margin Settings
Page Count xx Top Margin
PSAC xx Bottom Margin
Installed Memory xxx MB Left Margin
Processor Speed xxxMHz Right Margin
Serial Number xxxxxxx Skew
CalStat xxxx Cyan Top Margin
CalSet x.xx x.xx x.xx Cyan Left Margin
x.xx x.xx Cyan Right Margin
Engine ID xx Cyan Skew
FSpeed xxx Cyan Bow
Printer Rev isi on Lev els Yellow Top Margin
Loader xx.xx.xxxx-x Yellow Left Margin
Kernel xxx.xx.xxxx-x Yellow Right Margin = x
Yellow Skew
Base xx.xx.xxxx-x
Network xxx.xx.xxxxx-x Yellow Bow
Magenta Top Margin
Network Drvr xx.xx.xxxx-x
Engine xx.xx.xxxx-x Magenta Left Margin
Font x.xxxxx-xx.x Magenta Right Margin = x
Magent Skew
magenta Bow
Dup Top Margin
Paper Source
Formatted Size
Straight
Quick Test
The Quick Test contains the following information:
• Print registration settings
Alignment diamonds at the left, right, top, and bottom
•
Horizontal lines to check for skew
•
)
or Stop ( ).
"Alignment" on page 3-7
= x
= x
= x
= x
= x
= x
= xx
= x
= x
= x
= x
= x
= x
= x
= x
= x
= x
= x
= x
= Tray 1
= xxxxxx
Direction of change
A positive value causes the left end of the scan
line to move down the page. A negative value
causes the left end of the scan line to move up
the page. The right end stays fixed. There is no
compression or expansion of the image.
for instructions on setting printhead
Skewed
Diagnostic aids
5025-2xx, 4xx
Previous
Next
Go Back
3-5