Removal Procedures; Front Cover Assembly Removal - Lexmark C540n Service Manual

5025-2xx, 4xx

Removal procedures

CAUTION
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly for personal safety and to prevent damage to the printer.
Disconnect any connections between the printer and PCs/peripherals.
Notes:
Remove the waste toner bottle, color toner cartridges, imaging unit, and media tray before removing other
•
printer parts. The imaging unit should be carefully set on a clean, smooth, and flat surface. It should also
be protected from light while out of the printer.
• Unless otherwise stated, reinstall the parts in reverse order of removal.
When reinstalling a part held with several screws, start all screws before final tightening.
•
• Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.

Front cover assembly removal

See the front cover assembly on
Open the front cover.
1.
2. Remove the operator panel. See
Remove the right cover assembly. See
3.
Remove the waste toner bottle. See
4.
Remove the four screws (A) from the cable cover, and remove the cable cover.
5.
Remove the screw (B) from the back of the waste toner cartridge ground connector.
6.
7. Remove the rear shield. See
Service Manual
4-2
for the part number.
page 7-3
"Operator panel logo plate" on page
"Right cover assembly removal" on page
"Waste toner bottle removal" on page
A
"Top cover assembly removal" on page
4-9.
4-12.
4-81.
B
4-13.
Previous
Next
Go Back