Paper Pick Motor Drive Assembly Removal-Standard Tray - Lexmark C540n Service Manual

Paper pick motor drive assembly removal—standard tray
See
"Paper pick motor drive assembly—standard tray" on page 7-5
Remove the toner cartridges, the waste toner bottle, and the imaging unit (IU). See
1.
removal" on page
Remove the left cover. See
2.
3. Remove the rear shield. See
Disconnect the paper pick motor drive assembly cable connector (A) fromJSP1 on the controller board.
4.
Pull the cable (B) through the opening, and free the cables from the retainers (C) on the left side.
5.
6. Partially reinstall the rear shield to protect the controller board, and turn the printer so the rear shield rests
on the table and the bottom is facing you.
Warning: For models with a wireless antenna, use supports to prevent the antenna from taking the weight
of the printer.
4-81, and see
"Imaging unit (IU) removal" on page
"Left cover assembly removal" on page
"Rear shield removal" on page
for the part number.
"Waste toner bottle
4-49.
4-6.
4-11.
Repair information
5025-2xx, 4xx
Previous
Next
Go Back
4-65