Fuser Exit Sensor Removal - Lexmark C540n Service Manual

5025-2xx, 4xx

Fuser exit sensor removal

See
"Fuser exit sensor" on page 7-7
Open the front cover.
1.
Remove the right cover assembly. See
2.
Remove the left cover. See
3.
Disconnect the two-wire fuser cable (A) from the LVPS.
4.
Note: You do not have to extract the cable.
Remove the screw and grounding washer (B) on the right side of the frame.
5.
Note: Be careful not to lose the grounding washer.
Disconnect the thermistor cables (C).
6.
Disconnect the exit deflector from the fuser shaft. See
7.
flag removal" on page
Note: You do not have to remove grounding screw or the bin-full/narrow media sensor flag.
Service Manual
4-36
for the part number.
"Right cover assembly removal" on page
"Left cover assembly removal" on page
4-30.
4-6.
"Exit deflector and bin-full/narrow media sensor
4-12.
Previous
Next
Go Back