Lexmark XM7100 Series User Manual page 306

Troubleshooting
•
Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.
Paper changes needed
Try one or more of the following:
•
Touch Use current supplies to clear the message and continue printing.
•
Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
•
Enable the parallel port. From the printer control panel, navigate to:
Network/Ports > Parallel [x] > Parallel Buffer > Auto
Note: The printer discards any data received through the parallel port.
Printer had to restart. Last job may be incomplete.
From the printer control panel, touch Continue to clear the message and continue printing.
For more information, visit
Reattach bin [x]
Try one or more of the following:
•
Turn off the printer, and then turn it back on.
• Reattach the indicated bin.
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the indicated bin.
4
Reattach the bin.
5
Connect the power cord to a properly grounded electrical outlet.
6
Turn the printer back on.
• Remove the indicated bin:
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the indicated bin.
4
Contact customer support at
•
From the printer control panel, touch Continue to clear the message and print without using the specified bin.
http://support.lexmark.com
http://support.lexmark.com
or contact customer support.
or your service representative.
306