On-Screen Display (Osd) Menus (Pelco Protocol); Command Lock (Locked) - Bosch MIC Series 550 Classic Installation And User Manual

MIC Series 550 Classic Camera
8

On-Screen Display (OSD) Menus (Pelco Protocol)

This chapter identifies and describes each OSD menu option, as well as the default setting for
each option, for Pelco protocol. For step-by-step instructions, see Section 9 Common User
Commands (unlocked), page 45 and Section 10 Advanced Features, page 48.
To open the main Setup Menu in Pelco protocol (locked commands): Press 95-PRESET for
approximately 2 seconds. The screen Setup Menu appears.
Setup Menu
Exit...
Command Lock:
Bosch Menu
Camera Setup
PTZ Setup
Edit Password
*FastAddress:
Advanced
Software Version
Ack and Reset Alarms
Restore All Settings
Reset All Memory
* = Factory Setting
Focus / Iris: Select
Setup Menu Choices:
Menu
Exit
Command Lock (L)
Bosch Menu (L)
Camera Setup
PTZ Setup
Edit Password (L)
FastAddress (L)
Advanced
Software Version
Ack and Reset Alarms
Restore All Settings (L) Restores all settings to their original default setting.
Reset All Memory (L)
8.1

Command Lock (locked)

The Pelco Command Lock Menu allows or prohibits the use of locked commands. The default
setting is ON.
NOTICE!
If the Command Lock is set to ON and you press Focus or Iris on a locked command, the
camera displays the on-screen message: "Command is Locked."
Bosch Security Systems, Inc.
On-Screen Display (OSD) Menus (Pelco Protocol) | en
OFF
Not Set
Description
Exits the menu.
Allows or prohibits accessing locked commands. (If password is set,
you are prompted to enter the password.
Accesses the full configuration menu and all camera settings.
Accesses adjustable camera settings such as White Balance and
Night Mode.
Accesses adjustable pan/tilt/zoom (PTZ) settings such as tours, scan
speed, edit presets, limit stops, recording, and AutoPivot settings.
Changes the password.
Sets or changes a camera address.
Displays the current software versions.
Acknowledges and resets active alarms.
Clears all settings, including scene shots, tours, and recordings
stored in the camera's memory.
Installation and User Manual
41
F.01U.276.622 | 1.0 | 2012.09