Keyboard Commands, Pelco Protocol; Special Preset Commands, Pelco Protocol - Bosch MIC Series 550 Classic Installation And User Manual

MIC Series 550 Classic Camera
6.3.4

Keyboard Commands, Pelco Protocol

Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a Command Number and 2) a Function key input.
The camera uses the PRESET command key to save and recall presets (pre-positions) 1
through 64.
NOTICE!
To save a preset, enter the desired number and hold the PRESET key for approximately two
(2) seconds. To recall a preset, enter the desired preset number (or command) and
momentarily press and release the PRESET key.
Keyboard Command User Action
0-Pattern
1-Pattern
2-Pattern
3-Pattern
4-Pattern
1 – Aux On / Aux Off Press
2 – Aux On / Aux Off Press
3 – Aux On / Aux Off Press
4 – Aux On / Aux Off Press
91 – Aux On
92 – Aux On
6.3.5

Special Preset Commands, Pelco Protocol

Some Pelco mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
Preset Command
33-PRESET
34-PRESET
80-PRESET
81-PRESET
82-PRESET
92-PRESET
93-PRESET
94-PRESET
95-PRESET
96-PRESET
97-PRESET
98-PRESET
99-PRESET
Bosch Security Systems, Inc.
Description
Press Initiates recording continuous playback based upon
current Recording setting (A or B) in the Setup Menu.
Press and hold Initiates recording based upon current Recording
setting (A or B) in the Setup Menu. Press ACK to end
recording.
Press Initiate Recording A continuous playback.
Press and hold Initiate Recording A. Press ACK to end recording.
Press Initiate Recording B continuous playback.
Press and hold Initiate Recording B. Press ACK to end recording.
Press Initiate the standard preset tour (Tour 1).
Press Initiate the custom preset tour (Tour 2).
Activates / deactivates alarm output 1.
Activates / deactivates alarm output 2.
Activates / deactivates alarm output 3.
Activates / deactivates alarm relay.
Press Activate Zone Scan (display zone titles).
Press Deactivate Zone Scan (re-move zone titles)
Description
Pans the camera 180° (Flip).
Goes to Zero Pan (original home position).
Toggles the Synchronization Mode between Line Lock and Internal
(Pelco Frame Scan). This command is available if commands are
unlocked using the Main menu.
Initiates Preset Tour 1.
Initiates Preset Tour 2.
Sets the Left pan limit for an AutoScan with Limit Stops enabled.
Sets the Right pan limit for an AutoScan with Limit Stops enabled.
Initiates a Preset Tour.
Enables or disables Limit Stops in the Setup Menu for AutoScan.
Invokes the Pelco main Setup Menu when pressed for 2 seconds.
Stops a scan.
Initiates FastAddress (Pelco Random Scan).
Toggles the Synch. Mode between Line Lock and Internal (Pelco Frame
Scan). This command is available only for two (2) minutes after the
power is applied and then reverts to normal preset functionality.
Starts an AutoScan.
Installation and User Manual
Getting Started | en 25
F.01U.276.622 | 1.0 | 2012.09