Water Dispensing Spout Installation; Water Dispensing Spout Removal - Saeco Energica Operating Instructions Manual

6
INSTALLATION

WATER DISPENSING SPOUT INSTALLATION

In order to carry on with correct machine start-up, it is necessary to install the water dispensing spout.
The dispensing spout must always be inserted when operations requiring the dispensing of water have to be performed.
I
A
B
B
A = Water dispensing spout holes
B = Water dispensing spout pins
1
The water dispensing spout must be
inclined on the front.

WATER DISPENSING SPOUT REMOVAL

The following operations show how to properly remove the dispensing spout from the machine.
WARNING! CHECK THAT THE DISPENSING SPOUT IS COLD BEFORE TOUCHING IT WITH BARE HANDS: DANGER OF
BURNS. DO NOT FORCE THE INCLINATION OF THE DISPENSING SPOUT MORE THAN INTENDED.
1
Disengage the water dispensing spout
by lifting the locking device as shown in
the fi gure.
II
C
D
C = Machine couplings
D = Guides for water dispensing spout pins
2
C
A
At this stage the dispensing spout holes
(A) are lower than the couplings (C).
The dispensing spout pins (B) are located
at the same height as the guides (D).
2
Pull out the dispensing spout until it detaches.
DO NOT FORCE THE INCLINATION
OF THE DISPENSING SPOUT MORE
THAN INTENDED.
3
Insert the dispensing spout with a
combined rotation-pushing motion
towards the bottom (as indicated in the
fi gure), until it locks into place.