Saeco Energica Operating Instructions Manual page 37

32
MAINTENANCE
4
EMPTY TRAY UNDER
BREW GROUP
OK
Empty the drip tray placed under the
dispensing spout (page 36) and then
replace it on the machine.
Then, press the "OK" button.
7
STEP 1/2 DESCALING
PAUSE
The descaling cycle is activated.
The bar shows the cycle's progress.
This allows performing an ideal rinse cycle to ensure the best conditions to brew products.
The message about fi lling the tank for the rinse cycle is normal, as it is part of the procedure.
10
RINSE TANK &
FILL WITH WATER
OK
Rinse the tank and fi ll it again with
fresh drinking water up to the "MAX"
level.
Then, press the "OK" button.
5
FILL HALF CARAFE
WITH WATER. INSERT
IN BREW. POSITION
OK
Fill half the carafe with fresh water
(page 34).
Insert the carafe and place it in the
brewing position. Then, press the "OK"
button.
8
STEP 1/2 DESCALING
PAUSE
If the containers need to be emptied,
press the "PAUSE" button.
Then, press the "START" button when the
container has been emptied and replaced.
A default amount of water is needed for the rinsing step.
11 11
EMPTY TRAY UNDER EMPTY TRAY UNDER
BREW GROUP BREW GROUP
OK
OK
Empty the drip tray placed under the
dispensing spout (page 36) and replace it
back onto the machine.
Then, press the "OK" button.
6
PLACE A CONTAINER
UNDER
CARAFE DISP SPOUT
OK
Place a container under the carafe
dispenser.
Then, press the "OK" button.
9
RINSE TANK &
FILL WITH WATER
OK
At the end of the fi rst step, when the
descaling solution is fi nished, the
machine will require a tank rinse.
12 12
FILL HALF CARAFE FILL HALF CARAFE
WITH WATER. INSERT WITH WATER. INSERT
IN BREW. POSITION IN BREW. POSITION
OK
OK
Completely empty the carafe (page 34)
and fi ll it with fresh water.
Insert the carafe in the brewing position,
and then press the "OK" button.