Problems With The Dmz Interface; Problems With The Wan Interface; Table 216 Troubleshooting The Dmz Interface; Table 217 Troubleshooting The Wan Interface - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance
Hide thumbs Also See for ZyWall 35:
Table of Contents

Advertisement

ZyWALL 35 User's Guide

45.3 Problems with the DMZ Interface

Table 216 Troubleshooting the DMZ Interface

PROBLEM
Cannot access
servers on the DMZ
from the LAN.
Cannot ping any
computer on the
DMZ.

45.4 Problems with the WAN Interface

Table 217 Troubleshooting the WAN Interface

PROBLEM
Cannot get WAN IP
address from the
ISP.
562
CORRECTIVE ACTION
Check your Ethernet cable type and connections. Refer to the Quick Start Guide
for DMZ connection instructions.
Make sure the Ethernet adapters on the LAN computer and the DMZ server are
installed and functioning properly.
Verify that the IP address of the DMZ port and the LAN port are on separate
subnets.
Make sure that NAT is configured for your DMZ servers.
Check the 10M/100M DMZ LEDs on the front panel. One of these LEDs should
be on. If they are both off, check the cables between your ZyWALL and hub or
the station.
Verify that the IP address and the subnet mask of the ZyWALL and the servers
are on the same subnet.
CORRECTIVE ACTION
The ISP provides the WAN IP address after authentication. Authentication may
be through the user name and password, the MAC address or the host name.
Use the following corrective actions to make sure the ISP can authenticate your
connection.
You need a username and password if you're using PPPoE or PPTP
encapsulation. Make sure that you have entered the correct Service Type, User
Name and Password (the user name and password are case sensitive). Refer
to
Chapter 7 on page 127
If your ISP requires MAC address authentication, you should clone the MAC
address from your computer on the LAN as the ZyWALL's WAN MAC address.
Refer to
Chapter 7 on page 127
that you clone your computer's MAC address, even if your ISP presently does
not require MAC address authentication.
If your ISP requires host name authentication, configure your computer's name
as the ZyWALL's system name. Refer to
page
421.
or
Chapter 30 on page
447.
or
Chapter 28 on page
Chapter 3 on page 73
Chapter 45 Troubleshooting
427. It is recommended
or
Chapter 27 on

Advertisement

Table of Contents
loading

Table of Contents