Figure 273 Menu 15.1.1.1: Editing/Configuring An Individual Rule In A Set; Table 187 Fields In Menu 15.1.1; Table 188 Menu 15.1.1.1: Editing/Configuring An Individual Rule In A Set - ZyXEL Communications ZyWall 35 User Manual

Table 187 Fields in Menu 15.1.1 (continued)
FIELD
Action
Select
Rule
Selecting Edit in the Action field and then selecting a rule brings up the following menu,
Menu 15.1.1.1 - Address Mapping Rule in which you can edit an individual rule and
configure the Type, Local and Global Start/End IPs.
Note: An IP End address must be numerically greater than its corresponding IP Start
address.

Figure 273 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set

Type= One-to-One
Local IP:
Global IP:
Server Mapping Set = N/A
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.

Table 188 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set

FIELD
Type
Local IP
Start
End
Chapter 35 Network Address Translation (NAT)
DESCRIPTION
The default is Edit. Edit means you want to edit a selected rule (see following field). Insert
Before means to insert a rule before the rule selected. The rules after the selected rule will
then be moved down by one rule. Delete means to delete the selected rule and then all the
rules after the selected one will be advanced one rule. None disables the Select Rule
item.
When you choose Edit, Insert Before or Delete in the previous field the cursor jumps to
this field to allow you to select the rule to apply the action in question.
Menu 15.1.1.1 Address Mapping Rule
Start=
End = N/A
Start=
End = N/A
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are the
mapping types discussed in
servers of different types behind NAT to this computer. See
an example.
Only local IP fields are N/A for server; Global IP fields MUST be set for Server.
Enter the starting local IP address (ILA).
Enter the ending local IP address (ILA). If the rule is for all local IPs, then put the Start IP as
0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for One-to-One and Server
types.
Chapter 17 on page 295. Server allows you to specify multiple
ZyWALL 35 User's Guide
Section 35.4.3 on page 483 for
477