Configuring Wan Setup; Ethernet Encapsulation; Figure 50 Load Balancing: Spillover; Table 41 Load Balancing: Spillover - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 35:

Table of Contents

ZyWALL 35 User's Guide

The following table describes the related fields in this screen.

Active/Active

Load Balancing

Time Frame You can set the ZyWALL to get the measured bandwidth using the average

Send traffic to

secondary WAN

when primary

WAN bandwidth

7.8 Configuring WAN Setup

To change your ZyWALL's WAN ISP, IP and MAC settings, click WAN, then the WAN1 or

WAN2 tab. The screen differs by the encapsulation.

Note: The WAN1 and WAN2 IP addresses must be on different subnets.

The warning message "Warning! No NAT rule configured in system" appears in

the status bar when NAT is set to use Full Feature address mapping rules, but

there are no NAT address mapping rules configured.

The screen shown next is for Ethernet encapsulation.

Select Active/Active Mode and set the related fields to enable load balancing on the

Select a load balancing method to use from the drop-down list box.

bandwidth in the specified time interval.

Enter the time interval between 10 and 600 seconds.

Specify the maximum allowable bandwidth on the primary WAN. Once this maximum

bandwidth is reached, the ZyWALL sends the new session traffic that exceeds this

limit to the secondary WAN. The ZyWALL continues to send traffic of existing

session to the primary WAN.

Chapter 7 WAN Screens