Configuring Wan Setup; Figure 7-1 Route; Table 7-1 Route - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance
The following table describes the labels in this screen.
LABEL
Route Priority
WAN The default WAN connection is "1' as your broadband connection via the WAN port should
always be your preferred method of accessing the WAN. The default priority of the routes
Traffic Redirect is WAN, Traffic Redirect and then Dial Backup:
You have two choices for an auxiliary connection (Traffic Redirect and Dial Backup) in
Dial Backup
the event that your regular WAN connection goes down. If Dial Backup is preferred to
Traffic Redirect, then type "14" in the Dial Backup Priority (metric) field (and leave the
Traffic Redirect Priority (metric) at the default of "15").
The Dial Backup field is available only when you enable the corresponding dial backup
feature in the Dial Backup screen.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
7.4

Configuring WAN Setup

To change your ZyWALL's WAN ISP, IP and MAC settings, click WAN, then the WAN tab.
screen differs by the encapsulation.
When Network Address Translation is set to Full Feature, but there
is no NAT rule configured, the warning message "Warning! No NAT
rule configured in system" appears in the status bar.
7.4.1 Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.
7-2

Figure 7-1 Route

Table 7-1 Route

DESCRIPTION
The
WAN Screens