IBM 6400 Programmer's Reference Manual page 211

D72L032 LOCAL
CUADDR=B9F,
TERM=3286,
FEATUR2=(MODEL2,EDATS) ,
The EDATS parameter allows the use of structured fields.
ISTATUS=ACTIVE,
USSTAB=PUBSERL,
MODETAB=TABMODE,
DLOGMOD=PRTIPDS2
DLOGMOD is set to PRTIPDS2 (or any valid name) to point to the
MODEENT entry of the Logon Mode table.
MODEENT entries for the Logon Mode table in VTAM in DSC Mode:
PRTIPDS2 MODEENT
LOGMODE=PRTIPDS2,
FMPROF=X ' 02 ' ,
TSPROF=X ' 02 ' ,
PRIPROT=X ' 71 ' ,
SECPROT=X ' 40 ' ,
COMPROT=X ' 2000 ' ,
COMPROT describes to VTAM the LU protocol that is used for this logon
mode session. The value X
PSERVIC=X ' 00800000000018502B507F00 '
In addition to the above table entries, two structured fields are required. The
Data Chain indicator and the Select IPDS mode structured fields precede the
IPDS data stream as shown below:
Structured fields:
X ' 00060F216000 ' Data Chain indicator
X ' 00060F830000 ' Select IPDS mode
IPDS Data Stream:
Insert an IPDS data stream here.
Note: To force synchronous processing using CICS, use the CONVERSE
command with the ARQ bit on. The CONVERSE command is the equivalent of a
SEND data, WAIT on terminal, RECEIVE response sequence. The printer sends a
NACK as an X ' 80 ' .
IPDS for Control Units
' 2000 ' allows the use of structured fields.
Appendix B. Summary of IPDS for Control Units
195