SECTION 8—FRONT CASTERS
SECTION 8—FRONT CASTERS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
Installing/Replacing Six or Eight-Inch Front Casters and
Forks
If converting from a six-inch caster to an eight-inch caster or vice versa, there are
seat-to-floor height adjustments that MUST be made. Therefore, this procedure
MUST be performed by a qualified technician.
NOTE:!For!this!procedure,!refer!to!FIGURE 8.1!on!page!49.
NOTE:!This!procedure!can!be!performed!if!replacing!the!exact!same!size!front!caster.
1. Remove!the!dust!cover.
2. Remove!the!locknut!that!secures!the!fork!to!the!caster!headtube.
3. Drop!the!front!caster!and!fork!out!of!the!caster!headtube.
NOTE:!9000XDT!ONLY!"!Make!sure!to!reinstall!the!2"inch!extension!spacer.!See!Detail!#A#.
4. Slide!in!the!new!six/eight#inch!front!caster!and!fork.
5. Reassemble!by!reversing!STEPS!1#3.
6. Repeat!STEPS!1#5!for!the!opposite!front!caster.
7. To!properly!tighten!caster!journal!system!and!guard!against!flutter,!perform!the!
following!check:
A. Tip!back!of!wheelchair!to!floor.
B. Pivot!both!forks!and!casters!to!top!of!their!arc!simultaneously.
C. Let!casters!drop!to!bottom!of!arc!(wheels!should!swing!once!to!one#side,!then!
IMMEDIATELY!rest!in!a!straight!downward!position).
D. Adjust!locknuts!according!to!freedom!of!caster!swing.
8. Test!wheelchair!for!maneuverability.
9. Readjust!locknuts!if!necessary,!and!repeat!STEPS!7#8!until!correct.
10. Snap!dust!cover!over!the!locknut!and!stem.
9000 Series
WARNING
WARNING
48
Part No. 1056953