SECTION 9—ANTI-TIPPERS/WHEEL LOCKS
SECTION 9—ANTI-TIPPERS/WHEEL
LOCKS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
NOTE:!The!procedures!in!this!section!apply!to!non"recliner!models!only!except!where!noted.!For!
the!9000XT!recliner,!refer!to!Recliner!on!page 56.
Installing/Adjusting Anti-tippers
Anti-tippers are specific to the different seat-to-floor angles and/or seat-to-floor
heights. Refer to the chart in this section of the manual for correct usage and
adjustment. If these requirements cannot be achieved, DO NOT use the
wheelchair. Contact a qualified technician. If changing the seat-to-floor height with
or without a change to seat-to-floor angle, the correct anti-tippers MUST be used to
maintain a 1-1/2 to 2-inch ground clearance.
Seat-to-floor angle of 0° or 3°: If so equipped, anti-tippers MUST be attached at all
times. Inasmuch as the anti-tippers are an option for 0° or 3° on this wheelchair (you
may order with or without the anti-tippers), Invacare strongly recommends
ordering the anti-tippers as a safeguard for the wheelchair user.
Seat-to-floor angle of 6°: If changing the seat-to-floor angle to 6°, anti-tippers MUST
be ordered and installed.
Anti-tippers MUST be fully engaged and release buttons fully protruding out of
adjustment holes.
ALWAYS use anti-tippers. When outdoors on wet, soft ground or on gravel
surfaces, anti tippers may not provide the same level of protection against tipover.
Extra caution MUST be observed when traversing such surfaces.
Ensure both anti-tippers are adjusted to the same mounting hole.
Installing Anti-Tippers
NOTE:!For!this!procedure,!refer!to!FIGURE 9.1!on!page!51.
1. Remove!plug!button!(not!shown)!from!end!of!rear!frame!tubing!and!install!anti#rattles!
if!not!already!installed.
2. Press!the!release!buttons!in!and!insert!the!anti#tippers!with!the!anti#tipper!wheels!
pointing!toward!the!ground/floor!into!the!rear!frame!tubing!until!the!bottom!release!
button!locks!in!place.
9000 Series
WARNING
WARNING
50
Part No. 1056953