STEERING HEAD
3. Replace:
S bearings
S bearing races
a. Remove the bearing races from the steering
head pipe with a long rod 1 and hammer.
b. Remove the bearing race from the lower
bracket with a floor chisel 2 and hammer.
c. Install a new rubber seal and new bearing
races.
CAUTION:
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
S Always replace the bearings and bearing
races as a set.
S Whenever the steering head is disassembled,
replace the rubber seal.
4. Check:
S upper bracket
S lower bracket
(along with the steering stem)
Bends/cracks/damage ! Replace.
EAS00684
INSTALLING THE STEERING HEAD
1. Lubricate:
S upper bearing
S lower bearing
S bearing races
Recommended lubricant
Lithium soap base grease
2. Install:
S oil seal
S lower bearing
S outer race
3. Install:
S lower bracket
4-65
CHAS